Filament Guide submission page

image-for-filament-guide-cover

3D FilaPrint Filament Guide

A submission form for customers to upload details on their 3D prints showing how they were created.
  • You can also remain anonymous, so any name will do (within reason).
  • Your email address will only be used to inform you when your print submission has been added to the 3D FilaPrint Filament guide. This should be the email address you used when you purchased the filament from us.
  • Type your 3D printer model here.
  • Please select the 3D FilaPrint filament type, used to create the print.
  • Planning ahead for future nozzles - Thanks Luke 🙂
  • If the bed type is "other" please add it to the notes section at the end of this form.
  • If you chose hot bed, please specify the temperature in degrees centigrade
  • If the material type is "other" please add it to the notes section at the end of this form.
  • Please specify the temperature in degrees centigrade. If you changed the temperature during the print cycle, you can add a comment in the notes section at the end.
  • Did you use any supports or raft during the making of your print?
  • Please select the colour or colours used for you print.
  • Please type in the hours or minutes (or both).
  • Please provide the link to the download repository from where the file originated (if applicable). I.E Thingiverse, Shapeways, MyMini Factory, LayerbyLayer, TurboSquid, 3DBurrito, 3DContentCentral, XYZprinting
  • Please provide a clear photo and we will resize it for the finished entry into the 3D FilaPrint Filament guide.
    Accepted file types: jpg, jpeg, gif, png, pdf, pub, .
  • Please leave any additional notes here that you think a reader may need to create their own successful print.
  • This field is for validation purposes and should be left unchanged.
No comments yet.

Leave a Reply

Prove iT! *