Magnetic Iron PLA 1.75mm
Pictures and settings: motor housing for marble machine own openscad (see below) Kindly submitted by: Tony
Website:
Using a: Homebuilt and own designed 3D printer
Warm Blue Tape platform 50c
Nozzle Size: 0.4 E3D V5
Extrusion Temp 190c
Settings: Print Speed 25mm/sec Travelling speed: 50mm
Layer height 0.3 - Infill: 15%
Time to print: 65 minutes
Notes: This was printed using Proto-pasta Magnetic iron PLA. It prints easy as any PLA, at 190. The item was rusted by placing in salt solution for 2 to 3 days. Arranging the layers vertically, improved the rust streaking effect. The item is magnetic but cannot be magnetised.
Kindly submitted by: Tony
Website:
Using a: Homebuilt and own designed 3D p "Pin It")